Fichiers STL

This is my own designed fan duct for a 5015 fan to fit on a Hemera with a V6 hot end. This an ongoing project that has not been fully tested. Feel free to give it a try and let me know how it works for you. NOTE: Use M4x.0.7x20 to mount the fan and M3x.0.5x8 to mount to the extruder.

BIQU H2S Breakout Board Adaptor for Sidewinder and Genius Printers

This is the mount I use for a BL-Touch on my Sidwinder X1

Mounting Brackets to install a CAMXTOOL 10x11 Drag Chain on your TwoTrees SP-5

This is my my revised fan duct for a 5015 fan to fit on an E3D Hemera with V6, Volcano and REVO hot ends. NOTE: Use M4x.0.7x20 to mount the fan and M3x.0.5x8 to mount to the extruder.

Mounting Brackets to install an E3D Hemera Revo or Revo XS with dual 5015 fans on your TwoTrees SP5 or SP3.

Bracket to hold Bowden tube for direct drive extrusion systems on a TwoTrees SP-5

A remix of my preferred fan duct to fit a 5015 fan. This will clear the leveling probe on the Sidewinder X2.

Part Cooling Duct to use in conjunction with a BL-Touch using my SWX2/GPRO BL-Touch mounting bracket

Easily replace your stock probe on your Sidewinder X2 or Genius Pro with a BL-Touch, CR-Touch or 3D-Touch using this mount. Use M3 screws to mount. The nozzle to probe offset is close to stock so you can get by without updating the firmware with the new values but for maximum accuracy I suggest changing the values in the firmware.

Simple adaptor plate to mount an E3D Hemera to both Sidewinder and Genius 3D printers. Works with REVO, V6 and Volcano hot ends. BL Touch mount is stealthily hidden behind the extruder assembly and probes very close to the nozzle. Plenty of space to fit your cooling fan duct of choice. You can also download my cooling fan duct as well.

This is the spool holder and upper guides I use on my Sidewinder X1

Simple brackets to increase the rigidity of the Z axis to reduce z wobble. Use M3x12mm socket head cap screws with washers to mount to the stepper motors.

Sidewinder X2/GPRO Dual 5015 fan duct

It can be hard and time consuming to reach in the groove of the torpedo part of the edge pieces to clean them. This makes it way faster and easier.

A case to mount a BTT TFT 35 to your Artillery SWX1, SWX2 and Genius model 3D printers